As a homeowner, it’s likely you’re going to be dealing with a lot of home issues you’ve never considered. One of these may be that running toilet. Every time it flushes, the water keeps gushing. You can hear your money being flushed down the drain as your water bill increases. To help you solve this home problem, we’re going to discuss with you the most common causes of this issue.
Fill Tube Problem
One of the biggest reasons that a toilet continues to flow after flushing is that the fill tube has fallen out of its ideal position. When you open the tank lid on the back of your toilet, you’ll find a small flexible tube. This is known as the fill tube. It’s responsible for putting water in the overflow tube that leads it right into the bowl. It’s essentially responsible for filling the bowl back up after a flush. If the tube has fallen off the overflow tube, the bowl won’t fill up. This keeps the water running. To fix this problem simply reattach the fill tube to the overflow tube.
Bad Float Position
There is a large float in the toilet tank that is responsible for measuring the water level. When the water level in the tank reaches the level set by the float, the water stops pumping in. The problem that homeowners tend to run into when it comes to their toilet continuing to run is that their float is set too high. The float, which indicates when to shut off the water, is likely set above the overflow tube. This means the water pumped into the tank is simply draining into the overflow tube and never reaches the level where the float is set. This problem can be remedied by moving the float down below the overflow tube. A reliable plumber Raleigh NC residents can trust can help to adjust your float.
Flapper Chain Problem
Another common issue that Raleigh plumbers deal with is a broken flapper chain. Part of your toilet running smoothly is a functioning flapper. This is a rubber part that attaches to the bottom of the overflow tube. Its job is to stop the flow of water into the bowl after the tank has been refilled with water. When a flapper chain is broken or tangled, it won’t allow the flapper to completely seal shut. This means that water will continue to run underneath the flapper. This problem can be fixed easily once you identify the problem. In the event the flapper chain is broken, you’ll need to replace it. When installing the new chain, be sure to leave a little bit of slack so the flapper doesn’t get stuck in the up position. In the event the flapper chain is tangled, you need to tighten the chain to avoid that problem in the future.
As you learned above, the flapper is an important component that makes your toilet work. If the flapper is damaged, it won’t create a watertight seal when in the down position. This will lead to water continuing to run into the tank. This is typically a problem with flappers which are five to ten years old. To figure out if the flapper has damage, you should shut off the water valve to the toilet. Next, remove the flapper chain and unclip the flapper from the overflow tube. Every plumber Clayton, NC has will attest to the fact that not all flappers look the same. Depending on the age of your toilet, you may have a different looking flapper than a newer toilet.
It’s important that you use the right flapper to replace the old one or it won’t work to seal the water flow. Many of the newer toilets come with a universal flapper that can be purchased at your local hardware store. If the flapper has white corrosion around it, you may be able to simply remove the hard water deposits and reuse the flapper. Be sure to remove the hard water buildup that is around the entrance to the bowl.
Being a homeowner can be an exhilarating experience as you get to have your own independence. However, along with that independence comes responsibility. When your toilet continues to run after it’s been flushed a while ago, it’s likely due to one of the issues explained above. You should assess the problem and decide on a solution. If you don’t feel that you’ve properly identified the issue, it’s a good idea to call in a plumbing professional to help.